Welcome, Guest
Username: Password: Remember me

TOPIC: WeeBee Views

WeeBee Views 3 years 11 months ago #35112

  • GaryJ
  • GaryJ's Avatar
  • Offline
  • Posts: 11
If you copy and paste these sections into the panel cfg [VIEWS] section of Ted Cook's wonderful WeeBee. You can then use the Look down 'Numpad 5' and Look Rear 'Numpad 2' whilst in the VC and it allows you to peak over the left and right side of the engine. Should work with most monitor sizes;)

VIEW_REAR_DIR=12.0, 0.0, 0.0
VIEW_REAR_EYE=0.2, 0.03, 0.0

VIEW_DOWN_DIR=12.0, 0.0, 0.0
VIEW_DOWN_EYE=-0.2, 0.03, 0.0


Gary
The administrator has disabled public write access.

Re: WeeBee Views 3 years 11 months ago #35117

Nice and sneaky Gary.
This would be useful in the Comper Swift as well.
I was relying the [CTL]+[SHF]+[CR] routine for this.
Regards, Ted.
The administrator has disabled public write access.

Re: WeeBee Views 3 years 11 months ago #35132

  • GaryJ
  • GaryJ's Avatar
  • Offline
  • Posts: 11
It does work for the Comper as well.
Most of those FS9 VC snap views are never used, the default view is either staring at your shoes or the head rest. Some nice view combo's can be created. I usually make the 'down' view in my aircraft look down at the lower gauges or throttle quadrant, make flying more fun instead of fumbling with ctrl shft etc...
The administrator has disabled public write access.